Installation Guide

5
ASSEMBLY INSTRUCTIONS
Canopy Chain
Loop
Canopy
Lock Ring
4
6
5. Pull the supply wires and ground wire up through
the fixture chain (B), alternating links.
Unthread the canopy lock ring preassembled to
crossbar assembly (A) and slide it and the ceiling
canopy (D) down the fixture chain (B). Push all
slack fixture wire through canopy chain loop on
crossbar assembly (A) and into outlet box. Trim
excess fixture wire, leaving a minimum of 6 in.
hanging out of the outlet box.
5
B
E
Supply Wires
6.
Outlet Box
B
D
Lowes.com/portfolio
Canopy Chain
Loop
B
C
A
C
4. Adjust the fixture chain (B) to the desired length,
removing links if needed. Connect one end of the fixture
chain (B) onto the canopy chain loop preassembled to
crossbar assembly (A) with one quick link (C) and then
connect the other end of the fixture chain (B) to the
fixture loop (E) with another quick link (C).
Note: You may need to use pliers (not included) to open
the links of fixture chain (B). If so, put a cloth over the
fixture chain (B) to protect the finish from the pliers.
Suggested chain length for mounting over a 30-in.
table:
8-ft. ceiling: 10 inches of chain + 2 quick links
9-ft. ceiling: 22 inches of chain + 2 quick links
10-ft. ceiling: 34 inches of chain + 2 quick links