Installation Guide

4
ASSEMBLY INSTRUCTIONS
1
1. Thread the fixture loop (E) onto the top end of the
fixture assembly (F). Hand tighten until snug.
x 2
Hardware Used
2
2. Secure the crossbar assembly (A) to the outlet
box (not included) with outlet box screws (BB).
Tighten until snug.
Note: The preassembled mounting nipple on the
crossbar should protrude outward.
Outlet
Box
Screw
BB
E
F
3
Lowes.com/portfolio
3. Remove the preassembled canopy lock ring from
crossbar assembly (A). Temporarily attach the
canopy (D) to the preassembled nipple on the
crossbar assembly (A), securing with canopy lock
ring. If the canopy (D) is not snug against the
ceiling, remove it from the crossbar assembly (A)
and adjust the length of the preassembled nipple by
unscrewing the preassembled hex nut. Screw the
nipple in or out of the crossbar until the correct
length is achieved, then re-attach the canopy (D).
A
BB
Outlet Box
I
D
Outlet
Box
Canopy Chain
Loop
Hex Nut
Canopy
Lock Ring