Installation Guide

J
CC
AA
Tabs
2
4
Lowes.com/
p
ortfolio
2.
1.
ASSEMBLY INSTRUCTIONS
LAMP ASSEMBLY:
Align holes at ends of leg support (J) with holes in
tabs on legs (I).
NOTE: Leg support (J) should be turned so hole in
center for bottom finial (CC) faces towards the floor
when table is upright.
Attach one end of leg support (J) to leg (I) with
screw (AA). Insert screw (AA) with fingers first
and then tighten screw with Allen wrench (BB).
Before securing screws (AA) permanently, repeat
procedure for remaining ends of leg support (J).
Secure all screws (AA).
Attach bottom finial (CC) to center of leg support (J).
1
Screw tube (F) into base (G) then screw switch
assembly (E) into tube (F). NOTE: Keep cord
taut during entire installation, ensuring it does not
get tangled or pinched between the tube and/or
the base.
Place harp (C) into preassembled saddle.
C
Screw x 12
Hardware Used
AA
Allen Wrench x 1
BB
Bottom Finial x 1
CC
G
E
F
I
J
CC