Instructions / Assembly
Dimmer Notes:
1) Start time is measured at the lowest dimmer setting.
2) Some LED rated dimmers have a "rapid start" design used to provide a momentary power boost for LED and CFL
lamps during start-up. When a LED luminaire is on a dimmer with "rapid start" the boost may cause a momentary
flash of the LED lighting. This "flash" is generated by the dimmer, and may be more noticeable when the dimmer is
at a low setting. A solution is available in the following CWD dimmers which provide adjustment capability of the
"rapid start": Devine (DAL06P), Accell (AL06P), and Trace (TAL06P). Refer to product specifications online at www.
cooperwiringdevices.com for more details.
Dimming Guide Disclaimer:
1) CC is Cooper Controls, part of Eaton's Cooper Lighting business. CWD is Eaton's Cooper Wiring Devices
business.Cooper Controls and Cooper Wiring Devices brand names, where identified above, are trade names or
trademarks of Eaton or its Affiliates.
Leviton
®
is a registered trademark of Leviton Manufacturing Co. Inc., Lutron
®
is a registered trademark of Lutron
Electronics Co. Inc., Lightolier is a registered trademark of Philips Lighting, and any other brands are trade names or
trademarks of their respective company, and are not associated with Cooper Controls or Cooper Wiring Devices.
2) Testing conducted by Cooper Lighting is not a substitute for and does not imply certification by an independent
laboratory or any other standards certification.
Refer to the manufacturer specifications for more detailed information on product certifications and standards.
3) This is a representative list of typical dimmers as tested by Cooper Lighting for performance with the designated LED
luminaires only. Test data contained in this literature is based upon dimmers obtained in the marketplace.
Information about these other manufacturers products is obtained from packaging and published information made
available by the manufacturer and is deemed to be reliable, but has not been verified.
Dimmer performance and perceived limitations of the dimmers are based onfactors outside of Cooper Lighting's
control.
The specifications of these dimming controls and their conditions of use may change without notice to Cooper Lighting
or any other user.
Cooper Lighting makes no specific recommendation on product selection and there are no warranties of performance
or compatibility implied.
Installer must ensure proper local and national electrical codes are followed; and that the dimmer application and
condition of use is per dimmer manufacturer instructions and guidelines.
Dimmer Features ACCELL
(AAL06)
DEVINE
(DAL06P)
SKYE
(SAL06P)
Rapid Start feature
Selectable
ON or OFF
Fully adjustable Fixed ON
Adjustable high-end trim
•
Adjustable low-end trim
• • •
Wiring configurations
Single-pole or
multi-location
Single-pole or
three-way
Single-pole or
three-way
Color change kits • •
Note: The Rapid Start feature is used to ensure the right amount
of power boost during start-up. When a dimmer with Rapid Start is
turned on from a low dimmer setting, the LED lighting may exhibit
a momentary flash. Select dimmer models offer an adjustment of
the Rapid Start feature. The user may wish to adjust this setting to
reduce the boost and resulting momentary flash. If this capability is
desired, the user should select dimmer models designated as “fully
adjustable” or “selectable ON or OFF”.
Eaton's AL Series dimmers offer versatile
options to set the mood and reduce energy
consumption.
Visit www.cooperwiringdevices.com/ALSeries
for more information.
Incandescent and Electronic Low Voltage Rated Dimmers
- For Reference Only
14