Installation Guide

Lowes.com/

ortfolio

Place fabric shade (F) on a flat, clean surface with

the preassembled spider fitter side down. Place side

support (I) inside fabric shade (F) so one of the arms

on the spider fitter is positioned at middle of side

support (I).

Note: Make sure to turn side support (I) so the curve

of side support (I) fits along the curve of the fabric

shade (F).

ASSEMBLY INSTRUCTIONS

TABLE LAMP ASSEMBLY:

Adjust power cord length by pulling power cord

from bottom of table lamp (K) until taut.

Screw switch assembly (J) into table lamp (K), then

place harp (H) into preassembled saddle.

Power Cord

Raise fabric shade (F) and insert the ends of side

support (I) into holes along the frame at bottom of

fabric shade (F). Ensure the ends have been

inserted completely.

Repeat for the remaining two side supports (I).

Holes

Curved Side

Spider Fitter