Installation Guide

5
4
Hardware Used
Hardware Used
x 2
Hardware Used
x 3
Wire nut
x
x
2
2
x 1
2
2
x
x
ASSEMBLY INSTRUCTIONS
1
2
3
Outlet box screw
Decorative nut
Decorative nut
Mounting screw
Mounting screw
1. Remove decorative nuts (DD) from mounting
screws (AA) preassembled on crossbar (EE).
Then, attach crossbar (EE) to outlet box (not
included) with outlet box screws (BB). Note: The
mounting screws (AA) should protrude away from
the outlet box.
3. Attach wire nuts (CC). Tape wire nuts (CC)
and wires together.
B
B
AA
AA
B
BB
B
B
DD
DD
B
EE
Crossbar
B
CC
AA
DD
BB
EE
CC
ASSEMBLY INSTRUCTIONS
4
5. Install glass shade (B) on wall xture (A). Secure
with preassembled side screws (C).
5
C
A
6
4. Install light bulb (not included). Use one 60-
watt max. standard-base bulb or one 13-watt
standard-base CFL.
6. Insert wall xture (A) through the protruding
mounting screws (AA) and secure with
previously removed decorative nuts (DD).
Then, add silicone sealant (not included)
between mounting surface and canopy of wall
xture (A), leaving the bottom clear so moisture
can drip down.
B
AA
A
DD
Lowes.com Lowes.com
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers (not
included), black to black (power) and white to
white (neutral). Attach copper wire to ground
wire. Helpful hint: If necessary, attach copper
ground wire to grounded junction box.
or