Installation Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1
2
3
Cap nut
Long mounting screw
Short mounting screw
Crossbar
x 2
x 2
x 2
x 1
x 3
x 2
x 2
3. Attach wire nuts (BB). Tape wire nuts (BB)
and wires together with electrical tape (not
included).
Wire nut
Cap nut
Short mounting screw
B
AA
B
CC
B
B
DD
EE
B
B
BB
AA
BB
ASSEMBLY INSTRUCTIONS
4
5
6
6. Install light bulbs (not included). Use 60-watt max.
standard-base incandescent bulbs or halogen/
CFL/LED equivalents.
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers (not
included), black to black (power) and white to
white (neutral). Attach copper wire to ground
wire. Helpful hint: If necessary, attach copper
ground wire to grounded outlet box.
EE
AA
A
B
AA
DD
C
CC
DD
4 5
B
DD
1. Take off cap nuts (AA). Then attach the
crossbar (EE) by tightening the long mounting
screws (CC) securely into the outlet box. The
short mounting screws (DD) should protrude
away from the outlet box.
4. Screw nials (C) onto the xture. Place xture
(A) onto short mounting screws (DD). Secure with
cap nuts (AA). Note: The xture (A) can be
installed with the sockets facing either up or
down.
5. Remove socket rings (B). Install glass shade
(sold separately) over sockets of xture (A),
then secure with socket rings (B).
A