Installation Guide
ASSEMBLY INSTRUCTIONS
1
2
3
x 1
x 1
x 1
x 1
x 1
Wire nut
Mounting Screw
Crossbar
x 2
x 1
Canopy
Ring
Chain
Screw Collar Loop
Crossbar
Hardware Used
Hardware Used
Hardware Used
1. Remove chain (FF), ring (EE) and screw collar
loop (DD) from preassembled threaded nipple
on crossbar (CC). Then, attach crossbar (CC) to
outlet box (not included) using mounting screws (BB).
Note: The threaded nipple should protrude outward.
3. Pull out the supply wires and supply ground
wire from the outlet box. Strip 3/4 in. of insulation
from wire ends.
Make wire connections:
•
Connect the smooth wire (marked) from xture
to the black supply wire with a wire nut (AA).
•
Connect the ridged wire (unmarked) from xture
to the white supply wire with a wire nut (AA).
•
Attach the xture ground wire to the crossbar (CC)
with the preassembled green ground screw. Then
connect it to the supply ground wire with a wire
nut (AA). Tape wire nuts (AA) and wires together with
electrical tape (not included) and carefully tuck wires
back into the outlet box.
B
B
B
B
B
B
B
B
CC
AA
BB
CC
DD
EE
FF
GG
CC
DD
FF
GG
EE
A
2. Attach screw collar loop (DD) to the threaded nipple of
crossbar (CC). Choose the desired length of
chain (FF), using a soft cloth and pliers
(none included) to avoid damaging the nish of
chain (FF) if any links are being removed.
Note: The top and bottom section of chain (FF) are
required.
Open the top section of the chain (FF) and attach it to
the screw collar loop (DD). Pass the chain (FF)
through canopy (GG) and ring (EE). Then weave the
xture wire and the xture ground wire from xture (C)
through the chain (FF), ring (EE), canopy (GG), screw
collar loop (DD) and the threaded nipple on
crossbar (CC).
x 3
Lowes.com/portfolio Lowes.com/portfolio
4
ASSEMBLY INSTRUCTIONS
5
4. Screw the pole (A) onto decoration (B) and set aside.
Disassemble knob (K), cover (F) and hex nut (J) from
the threaded nipple (I), then screw the threaded
nipple into decoration (B).
5
5. Choose desired installation method, with all of the
sockets of xture (C) facing either upward or
downward. Insert plug (G) from decoration (B) into
slot (H) of xture (C), then secure xture (C) onto the
threaded nipple (I) using the hex nut (J), cover (F)
and knob (K).
4
AA
BB
CC
A
A
B
B
I
F
F
C
C
H
H
G
G
I
J
J
K
K