Installation Guide

6
Lowes.com/portfolio
7
ASSEMBLY INSTRUCTIONS
D
G
G
H
I
C
H
C
F
K
E
J
C
7
7. Remove preassembled check rings (E) from sockets
of xture (C). Install glass shades (D), then secure with
check rings (E). Install light bulbs (not included). Use
60-watt max. standard-base incandescent bulbs or
halogen/CFL/LED equivalents.
Assembly is now complete.
8
8. To reverse the direction of the sockets after the
initial installation, rst remove knob (K), and
cover (F) and save them for later use.
x 1
x 1
x 1
x 1
x 1
Ring
Chain
Screw Collar Loop
Crossbar
Canopy
B
B
B
B
B
DD
CC
EE
FF
GG
Hardware Used
6. Tighten ring (EE) onto screw collar loop (DD) to secure
canopy (GG) over crossbar (CC). Open the bottom
section of the chain (FF) and attach it to the ying ring
preassembled on pole (A).
GG
DD
EE
A
FF
CC
6
Lowes.com/portfolio
ASSEMBLY INSTRUCTIONS
10
10. Remove the plug (G) from the slot (H), then remove
the xture (C) from the threaded nipple (I). Reverse
the xture (C), inserting the new plug (G) into the
slot (H).
11
11. Re-tighten the hex nut (J) to secure xture (C) on
threaded nipple (I). Then, re-attach cover (F) and
knob (K) to complete re-installation.
9. Remove hex nut (J) from the threaded nipple (I).
Note: The assistance of another person is
recommended to hold up xture (C) during this step.
9
J I
C
K
F