Installation Guide

Lowes.com/portfolio
4
ASSEMBLY INSTRUCTIONS
3
4
5
5. Install light bulbs (not included). Use three 60-watt
max. candelabra-base bulbs or three 13-watt max.
candelabra-base CFL bulbs.
Lowes.com/portfolio
or
5
ASSEMBLY INSTRUCTIONS
1
Mounting screw
Crossbar
x 2
x 1
Hardware Used
B
B
BB
CC
2
x 1
x 1
x 1
x 1
x 1
x 1
x 1
Canopy
Ring
Ring
Chain
Screw collar loop
Screw collar loop
Crossbar
Hardware Used
B
B
B
B
B
B
B
CC
DD
DD
EE
EE
FF
GG
AA
Wire nut
Hardware Used
3. Pull out the supply wires and supply ground
wire from the outlet box. Strip 3/4 in. of insulation
from wire ends.
Make wire connections:
•
Connect the smooth wire (marked) from xture
to the black supply wire with a wire nut (AA).
•
Connect the ridged wire (unmarked) from xture
to the white supply wire with a wire nut (AA).
•
Attach the xture ground wire to the crossbar (CC)
with the preassembled green ground screw. Then
connect it to the supply ground wire with a wire
nut (AA). Tape wire nuts (AA) and wires together with
electrical tape (not included) and carefully tuck wires
back into the outlet box.
B
AA
x 3
GG
CC
DD
EE
x 1
x 1
x 1
x 1
Ring
Screw collar loop
Crossbar
Canopy
B
B
B
B
DD
CC
EE
GG
Hardware Used
4. Lift canopy (GG) up over crossbar (CC), securing by
tightening ring (EE) onto the screw collar loop (DD).
1. Remove ring (EE) from the preassembled screw
collar loop (DD). Then, attach crossbar (CC) to outlet
box (not included) using mounting screws (BB).
Note: The threaded nipple should protrude outward.
BB
CC
CC
DD
FF
GG
EE
A
B
2. Choose the desired length for chain (FF), using
pliers (not included) to remove links from chain (FF)
as needed.
Note: The top and bottom section of chain (FF) are
required.
Secure the decoration (A) to the cover (B). Open
the top link of the chain (FF) and attach it to the screw
collar loop (DD). Pass the chain (FF) through ring (EE)
and canopy (GG). Open the bottom link of the chain
(FF) and attach it to the decoration (A). Then weave
the xture wire and the xture ground wire through
the chain (FF), ring (EE), canopy (GG), screw collar
loop (DD) and threaded nipple of crossbar (CC).
Lift canopy (GG) up over crossbar (CC). Adjust the
screw collar loop (DD) on the crossbar (CC) as
needed until the canopy (GG) is ush against the
ceiling once tightened with ring (EE).
Note: Do not install canopy (GG) or ring (EE) yet!