Installation Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1
2
3
Cap nut
Mounting screw
Machine screw
Crossbar
x 2
x 2
x 2
x 1
x 3
x 2
x 2
3. Attach wire nuts (BB). Tape wire nuts (BB)
and wires together with electrical tape (not
included).
Wire nut
Cap nut
Mounting screw
B
AA
B
CC
B
B
DD
EE
B
B
BB
AA
BB
ASSEMBLY INSTRUCTIONS
4
5
6
6. Install light bulb (not included). Use 60-watt max.
candelabra-base bulb or halogen/CFL/LED
equivalent.
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers (not
included), black to black (power) and white to
white (neutral). Attach copper wire to ground
wire. Helpful hint: If necessary, attach copper
ground wire to grounded outlet box.
A
B
B
C
D
CC
AA
4 5
B
CC
1. Remove cap nuts (AA) from mounting screws (CC)
preassembled to crossbar (EE). Attach crossbar
(EE) to the outlet box (not included) with machine
screws (DD). Note: The mounting screws (CC)
should protrude away from the outlet box.
4. Place xture (B) onto mounting screws (CC).
Secure with cap nuts (AA).
5. Remove socket ring (D) with tool (C). Install
glass shade (A) over socket of xture (B), then
secure with socket ring (D) by using tool (C).
EE
AA
DD
CC