Installation Guide

Unwrap BARE wire (on mounting strap (C)) from

BLACK and WHITE fixture wires.

Remove mounting strap (C) from fixture (A) by

removing mounting strap screws (D) from the edges

of the fixture (A).

Save mounting strap screws (D) for later use.

ASSEMBLY INSTRUCTIONS

Washer

Outlet

Box

Attach mounting strap (C) to outlet box (not included)

using the existing washers and outlet box screws or

the machine screws (BB). NOTE: If the outlet box

screws required for your outlet box are of a different

size than the machine screws (BB), consult with a

licensed electrician before proceeding.

Tighten machine screws (BB) completely to secure

mounting strap (C) to outlet box.

CAUTION: Make sure the outlet box can support

35 lbs. hanging weight. Use metal outlet box; plastic

outlet boxes are not recommended.

Hardware Used

Machine Screw

x 2

If you wish to change cord length, loosen cord

restraint preassembled on the canopy of fixture (A).

Adjust cord to desired length by pulling cord up

through canopy then re-tighten cord restraint.

CAUTION: Make sure to tighten cord restraint

completely after adjusting cord but DO NOT

overtighten cord restraint.

Cord

Restraint

Canopy

BARE wire