Installation Guide

6
You may need to cut the excess wire to simplify the
wiring. You will need at least 10 inches of wire to work
with.
Prepare wire by stripping 3/4 in. of insulation from
wire ends using wire strippers (not included). Tie wire
into a knot.
Connect BARE/GREEN ground wire from outlet box
to BARE wire from fixture (A) using wire connector
(AA). Connect WHITE wire from fixture (A) to WHITE
wire from outlet box using wire connector (AA).
Connect BLACK wire from fixture (A) to BLACK wire
from outlet box using wire connector (AA).
NOTE: Screw wire connectors (AA) on in a clockwise
direction.
WARNING: Never connect ground wire to white
or black power supply wires.
WARNING: To reduce the risk of fire, electrical
shock or personal injury, wire connectors (AA)
provided with this light fixture are designed to accept
only one 12-gauge house wire and two lead wires
from the light fixture. If your house wire is larger than
12-gauge or there is more than one house wire to
connect to the corresponding fixture lead wires,
consult an electrician for the proper size wire
connectors to use.
Hardware Used
Wire Connector x 3
7a.
Lowes.com/
p
ortfolio
AA
ASSEMBLY INSTRUCTIONS
7a
7b.
A
B
AA
AA
AA
7b
Outlet Box
White
Fixture Wire
White Wire from
Outlet
Box
Black
Fixture
Wire
Black
Wire from
Outlet Box
Bare/Green
Wire from
Outlet Box
Bare
Wire
from
Fixture
Cord
Restraint
36
If you wish to change cord length, loosen cord
restraint preassembled on the canopy of fixture (A)
with a flathead screwdriver (not included). Adjust
cord to desired length by pulling cord up through
canopy then re-tighten cord restraint.
CAUTION: Do NOT overtighten cord restraint.
6.
A
Canopy
10 inches
A