Installation Guide

ASSEMBLY INSTRUCTIONS

Attach mounting strap (C) to outlet box (not

included) using the existing washers and outlet

box screws or the machine screws (BB). NOTE: If

the outlet box screws required for your outlet box

are of a different size than the machine screws

(BB), consult with a licensed electrician before

proceeding. Tighten machine screws (BB)

completely to secure mounting strap (C).

CAUTION: The fixture must be mounted to

an outlet box that is supported by the building

structure. Plastic outlet boxes are not

recommended.

Outlet Box

Remove threaded ring (E) from screw collar loop (F)

and save for later use.

Temporarily place canopy (A) over mounting strap

threaded rod (D). NOTE: Canopy (A) should fit flush

against ceiling when mounted. Once threaded rod

(D) is adjusted, tighten hex nut (G) securely against

mounting strap (C).

Set canopy (A) aside.

Hardware Used

Machine Screw

x 2

Attach one connecting chain link (CC) to fixture loop

(I) and then attach one end of the chain (B) to the

connecting chain link (CC). Close this connecting

chain link (CC).

Hook the other connecting chain link (CC) to the

screw collar loop (F) at the bottom of threaded rod

(D) on mounting strap (C)--leave this connecting

chain link (CC) open for now.

Hardware Used

Connecting Chain Link

x 2