Operating Guide

Wire
Connectors
Threaded
Knobs
AA
DD
CC
Long
Machine
Screws
BB
EE
Mounting
Bracket
Ground
Screw
(Not shown
to size)
FF
3
HARDWARE CONTENTS (shown actual size)
(Not shown
to size)
Please read and understand this entire manual before attempting to assemble, operate or install the
product. If you have any questions regarding the product, please call customer service at
1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
WARNING:
• IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Go to the main fuse box, or circuit breaker, in your home. Place the main power switch in the “OFF”
position and unscrew the fuses(s), or switch “OFF” the circuit breaker switch(es), that control the
power to the fixture or room that you are working on.
• Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull chain,
place it in the "OFF" position.
• Do not use bulbs with wattage greater than specified on this fixture.
• WARNING: California Prop 65: This lighting fixture contains chemicals known to the state of California
to cause cancer, birth defects, and/or other reproductive harm. Wash hands after use.
CAUTION:
• Read and understand all instructions and illustrations completely before proceeding with assembly
and installation of this fixture.
• If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a qualified licensed electrical contractor.
• All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out,
or use any parts that are worn out or broken. Failure to obey this instruction could invalidate the ETL
listing and/or C.S.A. certification of this fixture.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated assembly time: 30 minutes to 1 hour.
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire strippers,
electrical tape, ladder, safety glasses.
SAFETY INFORMATION
Qty: 3
Qty: 2
Thumb
Screws
Qty: 2
Qty: 2
Qty: 1
Qty: 1
GND
GND
GND
GND
G
ND
Short
Machine
Screws
GG
Qty: 2