Installation Guide

ASSEMBLY INSTRUCTIONS

6. Close the connector tight and rethread on the decorative

collar (D) and the decorative end cap (E). See Fig. 6.

NOTE: Never slide the track rail (G) within the power feed

stem (B) or support stem (F) as it will scratch the track’s

finish.

7. Install glass shade (I) onto the track head assembly (H)

and secure with spring clip (J).

See Fig. 7.

9. Unthread the decorative collar (D) on the track head

assembly (H) until it disengages from the threads and slides

freely on the shaft.

Unthread and remove the decorative end

cap (E) on the top of the connector. One side of the

connector will swing open exposing the track contacts.

See Fig. 9.

10. Align and insert the contacts on the track head assembly

(H) with the contact channel on the track rail (G), making sure

the “L” line contact inserts into the upper channel, "N" line

contact inserts into the lower channel and the ground tab

rests on the copper ground on top of the track rail.

See Fig. 10.

GROUND

TAB

GROUND

GROOVE

IDENTATION

TRACK

(FRONT)

TRACK

(BACK)

8. Attach the suction cup (EE) to the bulb (K), and

secure the bulb (K) to the socket on track head

assembly (H) by twisting and locking correctly. Detach

the suction cup (EE) from the bulb (K) by pulling the

small pin.

See Fig. 8.

Hardware Used

Suction Cup

x 1