Installation Guide

ASSEMBLY INSTRUCTIONS

2. Make electrical connections using wire connectors (BB).

Refer to ELECTRICAL CONNECTIONS in the Safety

Information section on page 3. Attach the power feed stem

(B) to the preassembled mounting bracket (A) using the

preassembled canopy screws (C). See Fig. 2.

4. On the power feed stem (B) and support stems (F),

unthread the decorative collar (D) until it disengages from

the threads and slides freely on the shaft. Unthread and

remove the decorative end cap (E) from power feed stem (B)

and support stem (F). One side of the connector will swing

open exposing the track contacts. See Fig. 4.

3. Determine the location of the support stems (F). Maintain

minimum 14 in. distance between each support stem (F).

Install support stem (F) on ceiling with the help of plastic

anchors (DD) and wood screws (CC). See Fig. 3.

Hardware Used

Plastic Anchors

x 4

Wood Screws

x 4

Hardware Used

Wire Connector

x 3

5. Determine ground side of track rail (G) (exposed copper

wire on top of the track rail) is facing the ceiling. In wall

applications, the copper ground should face the wall with

the contact channels (inserts with internal copper wire)

facing the ceiling. Note: The item should only be assembled

when grounds are correctly aligned. Insert the track into the

connector on the power feed stem (B) and support stems (F).

See Fig. 5.

GROUND TAB

GROUND

GROOVE

IDENTATION

TRACK

(FRONT)

TRACK

(BACK)

GROUND

GROOVE

IDENTATION