Installation Guide

SAFETY INFORMATION

WARNING

• Read all of these installation instructions before installing the track system.

• This system should be mounted to an electrical junction box at a minimum of 6 ft. above

ground level and 6 in. from any combustible material. The box must be directly supported by

the building structure.

• Do not install in damp or wet locations or on radiant heated ceilings.

• Do not cut any track sections.

• Before starting the installation, disconnect the power by turning off the circuit breaker or by

removing the appropriate fuse at the fuse box. Turning the power off using the light switch is not

sufficient to prevent electrical shock.

• Determine groundside of track (exposed copper wire on top of the track rail) is facing the ceiling.

In wall applications, the copper ground should face the wall with the contact channels (inserts

with internal copper wire) facing the ceiling. Should only be assembled when grounds are

correctly aligned.

• Do not attempt to energize anything other than lighting track fixtures on the track. To reduce the

risk of fire and electric shock, do not attempt to connect power tools, extension cords, appliances,

and the like to the track.

• Do not hang or drape anything from the track other than designated track components for this

system.

• All electrical connections must be in accordance with local codes, ordinances, and the National

Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services

of a qualified licensed electrician.

ASSEMBLY INSTRUCTIONS

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and diagram above. If any part is missing or damaged, do not attempt to

assemble the product. Contact customer service.

Estimated Assembly Time: 45 ~ 60 minutes.

Tools Required for Assembly (not included): Step ladder, Phillips screwdriver, Flathead

screwdriver, Wire cutters, Pliers, Safety goggles, Wiring supplies as required by Electrical Code.

Helpful Tools (not included): Wire stripper, Electrical tape

1. Install the preassembled mounting bracket (A) to the

junction box by using junction box screws (AA). See Fig. 1.

Hardware Used

Junction

Box Screws

x 2