Installation Guide

ASSEMBLY INSTRUCTIONS

Short Machine

Screws

x 2

x 1

Mounting

Bracket

x 1

Allen

Wrench

Hardware Used

GND

x 1

Allen

Wrench

Hardware Used

Outlet Box

(Not Included)

3. Marking the mounting position of the arm support

standoffs (J): Remove the couplings (G) from the

standoffs (J) with the Allen Wrench (JJ) by

loosening the Allen setscrew (K). Screw standoffs

(J) onto arm section (E). Temporarily position fixture

in place on mounting bracket (See Fig. 1.) and

mark on the ceiling the location of the standoffs (J).

Drill 1/8" diameter holes into the ceiling at these

marked locations. (See Fig. 3.)

1. Connect the mounting bracket (EE), with

short machine screws (BB), to the outlet box.

Orient the mounting bracket (EE) so that the

raised center portion protrudes into the outlet

box. (See Fig. 1.)

2. Attach extended arm sections (E) to center

section couplings (I) and secure with Allen set

screw (K), using Allen wrench (JJ). Note: While

attaching the arm sections the slack wire must

be pulled into the canopy (A) by gently pulling on

the wires (M) within the canopy marked with the

“PULL HERE” label (L). (See Fig. 2.)

Ceiling