Installation Guide

HARDWARE CONTENTS
Quantity
Picture
(Shown to size)
Wire
Connectors
2
Part
Threaded
Knobs
2
2
Long
Machine
Screws
AA
DD
CC
Description
Short
Machine
Screws
2BB
Quantity
Picture
(Not shown to size)
Part
EE
Description
Mounting
Bracket
1
Ground
Screw
1
(Not Shown
to size)
FF
Wrench 1
GG
(Not Shown to size)
3
GND
WARNINGS AND CAUTIONS
WARNING:
• IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the
"OFF" position.
• Unscrew the fuse(s), or switch "OFF" the circuit breaker switch(es), that control the power to the
fixture or room that you are working on.
• Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull chain,
place those in the "OFF" position.
• Do not use bulbs with wattage greater than specified on this fixture.
• WARNING: California Prop 65: This lighting fixture contains chemicals known to the state of
california to cause cancer, birth defects, and/or other reproductive harm. Wash hands after use.
CAUTION:
• Read and understand all instructions and illustrations completely before proceeding with assembly
and installation of this fixture.
• If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a qualified licensed electrical contractor.
• All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts
out, or use any parts that are worn out or broken. Failure to obey this instruction could invalidate
the ETL listing and / or C.S.A. certification of this fixture.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the product. Contact
customer service for replacement parts.
Estimated assembly time: 30 minutes to 1 hour.
Tools Required for Assembly: Phillips screwdriver, flathead screwdriver, wire strippers, electrical tape
(not included).