Installation Guide

7. Loosen the cable port screws at the bottom of the power
pack (E). Thread the pre-stripped low-voltage cables
into the cable ports and push
in firmly. Tighten the
screws securely.
OPERATING INSTRUCTIONS
After properly installing the power pack (E), turn
on the electrical source. There are two buttons
for operation. By pressing either button,
it will
turn to another working mode. Push either button
repeatedly to make a different selection.
"0"-- ON (lights stay on until manually turned off).
"A" --AUTO (Lights turn on at dusk and off at
dawn.)
"1"- "9"-- TIMING (Lights turn
on at dusk and off after
the selected number of hours.)
ll Hour
2 2 Hour
3 3 Hour
"'4 Hour
55 Hour
Ei 6 Hour
1 7 Hour
B 8 Hour Auto On at Dusk
g 9 Hour ~~!~ ~~~t:t c;!~.
A Auto On/Off "Dusk-to-Dawn"
a Manual On/Off
A UP 'Y DOWN
PUSH repeatedly
to select from 11
FUNCTIONS
If the manual circuit breaker trips, there is a risk of fire. Reset the unit or unplug the transformer and
check the following:
1. Is this cable correctly inserted into the power pack
terminals?
2. Is the unit overloaded or are the wires touching?
3. Are the fixtures correcly installed on the cable?
8
Lowes.com/portfolio