Installation Guide

ASSEMBLY

INSTRUCTIONS

For low-voltage cable connections, split one end

of the low-voltage cable approximately 2

in.,

and strip

about 3/4

in.

of insulation off each wire, then twist

strands together tightly.

Distribute the light fixtures as evenly as possible

along the low-voltage cable. Position the higher

wattage fixtures closer to the power pack

(E) and

lower wattage fixtures away from

it.

Note: The power

pack

(E) should be at least

10ft.

away from the first

fixture.

Determine the distribution of lights and calculate the total

length of low-voltage cable that

needed to connect

each light and return to the terminal block of power pack

(E).

Make sure not to cross the wires when routing them back

to the term ina I blocks. The wire coming from a

particular terminal screw must go back

the same

terminal screw. Note: The wire has a smooth side and a

rigged side for identification.

Please make sure the cables are securely connected to

the terminal block of power pack

(E) to prevent the risk of

fire, electrical shock, or damage to the power pack

(E).

____

1·_2_¥:

&14~.

12VAC

OUTPUT

Lowes.com/portfolio