Installation Guide

OPERATING INSTRUCTIONS
1.
After properly installing the power pack
(A),
turn
on
the
electrical source. There are two buttons for operation.
By pressing either button,
it
will turn to another working
mode. Push either button repeatedly to scroll through
different selections.
"0"
--ON (lights stay
on
until manually turned off).
"A"
--AUTO (lights turn
on
at dusk and off at dawn.)
"1"-
"9"
--TIMING (lights turn
on
at dusk and off after
the selected number of hours.)
ll
Hour
2 2 Hour
3 3 Hour
"'4
Hour
S 5 Hour
6 6 Hour
1 7 Hour
B 8 Hour
9 9 Hour
R
Auto
On/Off
nDusk-to-Dawnn
1C11
Manual
On/Off
CAUTION: If the manual circuit breaker trips, there
is
a risk of fire. Reset the unit by pressing the reset
button located
on
the bottom of the power pack after checking the following:
Cable
is
correctly inserted
in
the cable terminals at the bottom of the power pack and no
wire insulation
is
under the terminal clamping plate.
Check for overload or short circuits (wires touching) along the cable.
Check that fixtures are correctly installed
on
the cable and that there are no short circuits.
Make all repairs before pressing reset button and operating the lighting system.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Fixture doesn't work
1 . The power pack
is
not plugged
in
and turned
on.
2.
Low-voltage cables are not
connected to the power pack
properly.
3.
Fixture connector
is
not properly
installed
on
the low-voltage
cable.
4.
The power pack
is
overloaded.
5.
The manual circuit breaker has
tripped.
8
1.
Plug the power pack into the
outlet and turn the power pack
on.
2.
Ensure the wires are inserted
properly into the cable terminals
and the term ina I screws are
securely tightened.
3.
Make sure the connect pins
pierce wire insulation and make
proper contact with the wire.
4.
Check the total wattage of all
connected fixtures. Total wattage
must not exceed 150 watts per
terminal output capacity.
5.
Push the reset button
on
the
bottom of the power pack to reset
the circuit breaker.
Lowes.com/portfolio