Installation Guide

ASSEMBLY INSTRUCTIONS
8. When selecting a location for the fiber optic cable (B),
make sure it will receive direct sunlight. DO NOT mount
the fiber optic cable
(B) where it could sense artificial
light, as that might cause the lighting system to shut off
unexpectedly. Drill hole at depth of about 0.8
in. using
a 3/16
in. drill bit at desired location on an outside wall
and insert M3.5 anchor
(EE). Secure fiber optic cable
holder (AA) by inserting M3.5 x 20 mm screw (FF)
through the fiber optic cable holder (AA) and into the
M3.5 anchor
(EE).
Hardware Used
Fiber Optic Cable ,&
Holder ~
X 1
M3.5 Anchor c : : : : : J
X 1
M3.5 x 20 mm Screw <{\\\\\\\1\\\\\\IIJ
X 1
9. Insert fiber optic cable (B) into the photo eye socket
on the bottom of the power pack (A). Push in firmly
until you hear a "click". Make sure the fiber optic cable
(B)
is never crimped in any way.
If you want to test the photo eye during the day, plug the
power pack (A) into a GFCI outlet and cover the end of
the fiber optic cable
(B) with the preassembled black
plastic cover so the end of the fiber optic cable does not
receive any light. Press the power pack setting button
to
"A". The light fixtures will turn on. Uncover the end of
the fiber optic cable
(B) and the lights should shut off
automatically.
Note: There will be a 30-60 second delay between the
lights turning on/off once the end of the fiber optic
cable
(B) is covered/uncovered.
7
Photo Eye Socket
Black Plastic
Cover
Lowes.com/portfolio