Installation Guide

ASSEMBLY INSTRUCTIONS
6. Plug the power pack into the outlet and turn the
power pack
on (refer to operating instructions below).
Connect the light fixtures to the low-voltage cable (not
included) using fixture connectors, and test the system
before finalizing installation. Once testing
is completed
and the system
is operational, the cable may be covered
with landscape material (mulch, rock, etc.) or buried up to
6
in. deep.
Note: If the first light connection does not result
in the
light turning
on, refer to the troubleshooting section
on page 8. When the power pack (A) is on, an
audible hum may be heard. This is normal and does
not affect the performance of the power pack
(A).
7. Mount the power pack (A) to the wall by hanging the
power pack (A)
on the M5 x 35 mm screws (CC) by
means of the keyhole slots located
on the back.
6
0
Lowes. co m/po rtfol io