Installation Guide
ASSEMBLY INSTRUCTIONS
Recommended
installation
configurations
for
each
output terminal:
Combined Wattage
of
all
Recommended Cable
Using
12V
Recommended Cable Length
fixtures
Gauge
Less than
2
X 16
300W
(2
X 150W)
2
X 14
2
X 12
4.
Loosen the term ina I screws located on the bottom of the
power pack (A) and insert one
of
the pre-stripped wires
under the terminal clamping plate and securely tighten
the terminal screw. Repeat this process for the other side
of the wire, inserting it into the second wire terminal.
CAUTION: To reduce the risk
of
fire, electrical shock
or
damage to the power pack (A), ensure there
is
no wire insulation under the terminal clamping
plate and the screws connecting the cable to
the power pack terminals are securely
tightened.
5.
Lay a length
of
low-voltage cable
in
the general area
where the lights are to be installed. Distribute light
fixtures (not included) as evenly as possible along the
low-voltage cable.
Note: The first fixture should be a minimum
of
10ft.
away from the power pack (A).
5
2 x Less than 150 ft
2 x Less than 250 ft
2 x Less than 350 ft
•
10ft
0
\
• •
Lowes.com/portfolio