Installation Guide

32
PACKAGE CONTENTS
PART
DESCRIPTION
QUANTITY
A
Transformer
1
A
This transformer has a 200-watt circuit that powers up to 200 watts of light. To determine
the maximum number of fixtures that can be safely connected to this transformer, add the individual
wattage of all the fixtures. The total wattage of the fixtures must not exceed 200 watts output capacity.
CALCULATING LIGHTING CAPACITY
HARDWARE CONTENTS (shown actual size)
AA
BB
CC
Mounting Template
(not actual size)
Qty. 1
Anchor
Qty. 2
Phillips Screw
Qty. 2
SAFETY INFORM
ATION
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures: Reorient or
relocate the receiving antenna; Increase the
separation between the equipment and receiver;
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected; Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 30 minutes
SAFETY INFORMATION
W
ARNING
Please read and understand this entire manual before attempting to operate or install the product.
• The transformer is not suitable for use with submersible luminaries or pumps.
• This transformer is suitable for outdoor use ONLY.
• This transformer is for use with low-voltage landscape lighting systems ONLY.
CAUTION
combination shall be determined by UL
or other inspection authorities having jurisdiction.
ro segarag sa hcus aera desolcne na ni ro sroodni ,skced doow no remrofsnart tnuom TON OD•
crawl spaces.
• DO NOT repair or tamper with cord or plug.
• DO NOT use extension cords.
• DO NOT submerge the transformer in water.
• DO NOT connect two or more transformers together.
• DO NOT use the transformer with a dimmer switch.
• DO NOT install the transformer within 10 ft. of a pool, spa or fountain.
• Transformer MUST be mounted to a structure or a transformer stand in an upright position. DO NOT
lay the transformer on the ground after connecting it to a circuit.
• DO NOT bury the connectors or cables at depth greater than 6 in.
• DO NOT exceed the maximum wattage of the transformer capacity (200 watts).
• ONLY plug the transformer cord into a covered 120-volt Class A Type GFCI (ground fault circuit
interrupter) receptacle with a hooded flush type cover plate marked “WET LOCATION”.
T
ools Required for Assembly (not included): Phillips Screwdriver, Drill, 3/16 in. Drill Bit, and Wire
Strippers.