Installation Guide

23
TILTING THE TABLE (FIG. DD)
NOTE: The table (1) has a threaded hole
with a locking set screw inserted for locking
the table into a predetermined 0° horizontal
position.
1. Turn the nut (2) on the locking pin (4)
clockwise with an adjustable wrench to
RELEASE the locking pin (4) and pull it
out from the table (1).
2. LOOSEN the large hex head table bevel
locking bolt (3) and move table to desired
position then re-tighten.
To prevent injury, be sure to hold the
table and table bracket, so it will not
swivel or tilt.
Fig. DD
WARNING
!
METAL DRILLING (FIG. EE)
When metal drilling, always use a proper vise
or a clamp to secure the metal workpiece and
use metal drilling lubricant. The table has a
drain hole (1) and use a plug (PT3/8"-19) to
gather the drilling lubricant. When the drilling
lubricant is full or the drilling is completed,
remove the plug to drain the drilling lubricant
out and clean up the dust through the drain
hole (1).
Fig. EE
1
3
2
4
1