Installation Guide

19
Fig. U
LASER LABEL (FIG. U)
The label on your laser may include the
following symbols.
V .........................volts
mW......................milliwatts
nm.......................wavelength in nanometers
IIIa........................Class IIlA Laser
For your convenience and safety, the following
labels are on your laser. (Fig. U)
Cross Hair Alignment (FIG. R, T)
7. Place board (12) at on the table. Do not
allow the board to move from this position;
use clamps if needed. Bring the bit down
until it leaves a slight perforation in the
board; then raise it back up. (Fig. T)
8. Using a small screwdriver, loosen the laser
setscrew (13) and adjust (14), so the
laser line crosses the perforation. Tighten
setscrew (13). (Fig. R)
9. Adjust the other laser assembly in
the same manner until the laser lines
form cross hairs (15) exactly over the
perforation in the board. (Fig. T)
10.
Tighten setscrew (13-Fig. R). Re-check the
vertical alignment to insure that the laser
lines did not shift during the tightening
process. The laser is now calibrated
properly and the location of your holes
can be centered at the cross hairs for
accurate drilling.
11. Assemble guards with the screws (2) over
the laser on each side.
Fig. T
12
15