Installation Guide

15
Fig. G
INSTALLING FEED HANDLES (FIG. H)
1. Bag “B” - Locate the three feed
handles (1) in the loose parts bag.
2. Thread the three feed handles (1) into the
threaded holes (2) on the right side hub
assembly (3) and tighten.
Fig. H
INSTALLING THE CHUCK (FIG. I, J, K)
Before installing the chuck and arbor to the
drill press head, clean all mating surfaces
with a non petroleum based product; such as
alcohol or lacquer thinner. Any oil or grease
used in the packing of these parts must be
removed otherwise the chuck may come
loose during operation.
1. Bag “D, F” - Push the chuck (1) onto the
spindle arbor (2). Tap gently on the arbor
with a hammer or rubber mallet to ensure
a proper seat. (Fig. I)
Fig. I
6. Slide the table assembly (4) with the
rack (7) onto the column (9). (Fig. E)
7. Engage the bottom of the rack (7) with
the lip of the column support (10). Lock
the table assembly to the column using
the lock handle (2).
Fig. E
8. Replace the rack ring (6) and tighten.
(Fig. F)
9. Install the table crank handle (11) onto
the worm gear shaft (12).
10. Line up the at side of the shaft with the
set screw (13) in the table crank handle
and tighten the screw with a 3 mm
hex key.
Fig. F
INSTALLING THE HEAD (FIG. G)
The Drill Press head is very heavy and MUST
be lifted with the help of 2 people OR MORE
to safely assemble the Drill Press head on
the column.
1. Carefully lift the head (1) above the
column (2) and slide it onto the column.
Make sure the head slides down over the
column as far as possible. Align the head
with the base.
2. Tighten the two head lock set screws (3)
on the right side of the head with a 5 mm
hex key.
1
2
3
2
5
1
WARNING
!
WARNING
!
4
7
9
10
2
6
4
11
12
13
1
2
3