Installation Guide

14
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 20 ~ 35 minutes
ASSEMBLY INSTRUCTIONS
● For your own safety, never connect plug
to power source outlet until all assembly
steps are complete and you have read
and understood the safety and operating
instructions.
● The drill press is a heavy power tool
and should be lifted with the help of two
people OR MORE to safely assemble it.
ASSEMBLING COLUMN TO BASE (FIG. A)
1.
Position the base (1) on a at work surface.
2. Place the column (2) on the base, aligning
the mounting holes to the base.
3. Bag “D” - Locate the four hex bolts (3)
from the loose parts bag.
4. Place a hex bolt (3) in each hole through
the column support and thread into the
base. Tighten with a 17 mm hex wrench.
Fig. A
INSTALLING THE TABLE (FIG. B-F)
1. Bag “D” - Locate the worm gear (1) and
table lock handle (2) from the loose parts
bag. (Fig. B)
2. Insert the worm gear (1) into the table
crank handle hole (3) from inside the
table assembly (4). Make sure the worm
gear (1) meshes with the inside raising/
lowering gear.
3. Insert the table lock handle (2) from the
left to right into the hole (5) at the rear of
the table assembly.
Fig. B
NOTE: Table removed from bracket in
illustration for clarity.
4. Remove the rack ring (6) and rack (7)
from the column using a 3 mm hex
key (8). (Fig. C)
Fig. C
5.
Place the rack (7) into the table
assembly (4), making sure the worm
gear (1) on the inside of the table
assembly is engaged with the teeth of the
rack and the arrow stamped on the rack
is pointing up. (Fig. D)
Fig. D
3
1
2
6
7
8
WARNING
!
3
1
2
4
5
4
7
1