Operating Guide

ASSEMBLY (CONTINUED)

FENCE RAIL AND EXTENSION

WING ASSEMBLY

FIG. 8

FIG. 9

RAIL SUPPORT

Attached extension wing (M) to the table with (3) M5 x

10mm (3/8 in.) hex socket cap screws (g) and (2) M5 flat

washers (h) as shown in Fig. 8.

NOTE: Leave the screws loose enough to make

adjustments for leveling the extension wing (M) to the

table.

Level the extension wing (M) to the table as shown in

Fig. 8a and 8b using a straight edge ruler, then tighten

(3) M5 x 10mm (3/8 in.) hex socket cap screws (i) to

secure the extension wing in place.

Attached fence rail (N), scale side up (16” side of scale

to the right), to the front of the saw using (4) M5 x

25mm (1 in.) hex socket cap screws (i) as shown in

Fig. 9, making sure rail is properly seated on each rail

support on the front of the table.

Saw as assembled shown in Fig. 7.

FIG. 6

STAND ASSEMBLY

ATTACHING STAND TO SAW

Place saw (A) on stand assembly while aligning wing

screws with threaded holes in saw base. See Fig. 6 and

6a.

Tighten wing screws to secure stand assembly to saw

(A).

NOTE: Do not over tighten.

FIG. 7