Owner's Manual

DIGITAL CONTROLS
The user interface includes touch sensitive buttons for operation of the Portacool Hurricane™ 370. The user interface
also includes status indicator LEDs and a 7-segment display to show the status of the evaporative cooler.
Power
The green Power LED is illuminated when the evaporative cooler is plugged in.
Water level
TheredwaterlevelLEDisilluminatedwhentheoatswitchdetectsalowwaterlevelandthepumpisnot
turningon.ThisLEDashesifthepumpisrunningduringalowwateroccurrencetoindicatethatmorewater
needs to be added in order to continue running the pump.
Timer
Thecontrollerfeaturesvepre-programmedmodeswhichcontrolthefan/pumpsequenceforapre-dened
period.Eachtouchoftheprogrambuttoncyclesthroughthevemodes:1HR,2HR,4HR,8HR,andTIMER
OFF.Duringtheprogramrun,theusercanadjustthemaximumfanspeedwiththeup/downbuttons.When
theprogramisactive,theTimerLEDwillbeonand,forveseconds,theuserwillbeshownwhichprogram
(1H,2H,4H,or8H)isactive.
Pump
Pressthepumpbuttononcetopoweronandagaintopowero.ThegreenPumpLEDisilluminatedwhen
thepumpisenabled.TheLEDashesslowlyifcontinuouslyheldandthetimerisdisabled.
Fan
Whenthefaniso,touchthefanbuttononcetoturnthefanoninfullspeed.Whenthefanison,touchof
theFanbuttonagaintoturnthefano.ThegreenFanLEDisilluminatedwhenthefanisactive.TheLED
ashesslowlyifcontinuouslyheldandthetimerisdisabled.
Speeds
Thebuttonscontroltheairvelocityofthecooler.Beginningwith“Lo”,or30%airow,then50%,thenupto
“Hi”or100%airowandincreasinginvepercentincrements.
Twodigitsdisplaythecooler’stemperature,fanspeed,andtimerprogram.Ifthecoolerdoesnothavea
temperaturesensorconnected,thedisplaywillconstantlyshowfanspeed.Ifthecoolerdoesfeaturea
temperaturesensor,thenthetemperatureisdisplayedunless:afanspeedchangeisbeingcalleduponeither
bymeansoftheup/downbuttonorbythetimer’sprogram.Whenafanspeedchangeisrequested,thefan
speedwillbedisplayedforvesecondsbeforereturningtothecoolertemperature.
LOCK OUT FEATURE
Iftheoperatorwouldliketolocksettingssothattheycan’tbeadjusted,simplypressthe“up”arrowandthefanbutton
simultaneouslytolockthecontrols.Tounlock,pressthe“down”buttonandthefanicon.Whenenabled,“L-E”,or“Lock
Enabled”,willbedisplayedintheLED.
FAHRENHEIT VS CELSIUS
If the operator would like to change the temperature setting from Fahrenheit to Celsius, press the fan, motor and timer
buttons simultaneously. To switch from celsius to fahrenheit, simply repeat the process.
1
2
3
4
5
6
7
2
1
3
4
5
6
7