Product Manual

13
3.3.4 Using the tree/pole mount with anchor strap (PCA-1263, sold separately)
1)
(figure 1, no 1); then feed the sling’s end through the ratchet
3)
operly positioned. The pads should offer maximum contact surface with the tree or
4) hitch (without the square tubing) and fasten it with the hitch pin and
6) and start winching. The winch will align itself
automatically with the load (figure 6).
Place the tree/pole mount at the base of the tree or pole. Insert the sling’s hook into the
anchor point on the left
system (figure 1, no 2);
2) Slide the whole set-up upward to the desired height (figure 2);
Tighten the sling with the wrench supplied (figure 3) while making sure the rubber pads
are pr
pole;
Install the receiver
‘’R’’ pin (figure 4);
5) Attach the winch anchor hooks to the eye bolts (figure 5);
Wrap the rope around the drum
IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL
EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT
LATE. P
AFTER PULLING FOR A FEW SECONDS WITH THE TREE/POLE
MOUNT, RELEASE THE TENSION OFF THE PORTABLE CAPSTAN WINCH
TM
. CHECK THE
OLIDITY OF THE INSTALLATION AND TIGHTEN THE SLING AGAIN.
.4 Oil Alert
S
TM
3 system
The GX-50 Honda engine is equipped with an Oil Alert
TM
system that automatically turns off the
ignition when the oil level goes below a safe level. The Oil Alert
TM
system also turns off the