User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- 48: Back Cover
Made in China
For use with 90 connector
5VDC-IN
For use with
straight
connector
5VDC-IN
NBDVR380GWMNT
4
Locking Pins
These pins will locate and then allow the camera to be attached to the mount.
DC-IN Sockets
There are two sockets available, one for use with the supplied 90° car adaptor, the other
for use with the Nextbase Hardwire Kit (sold separately) which uses a straight connector.
Please contact your Nextbase retailer to purchase the Nextbase Hardwire Kit.
Cable Lock
The cable lock secures the car adaptor or hardwire kit cable to the mount.
Cable Lock Anti-Tamper Screw
Location of the anti-tamper screw, that can be used to secure the cable lock to the mount.
Adhesive Pad
Once the backing tape has been removed this adhesive pad will securely adhere the mount to
your windscreen.
Note:
- Before removing the red backing tape from the adhesive pad make sure you have determined
the optimum position for the Dash Cam (see page 26) and that the windscreen is free of dust
and/or dirt.
- A spare adhesive pad has been provided, in case you wish to change the mounts location.
1
1
5
2
3
4
Powered GPS Mount
Please see below to identify the parts of the supplied GPS mount.
2
3
5
10