www.popandlock.net (800) 342-5911 PL9555 (and PL9772) Power Lock Installation Instructions POWERED BY: 1) Locate and remove the Emergency Release Handle with Phillips screw. 2) Locate and remove the black plastic Dust Cover if one is installed. May need to cut it off if necessary. 3) Install the Lock Module by sliding it over the handle, be sure the mounting tab is at the bottom and lines up with the notch in the handle when sliding it on.
4) Install the Stainless Steel E-clip into the groove in the handle to hold the Lock Module in place. 5) Reinstall the Emergency Handle and cables to the rotary latch, route the passenger side cable through the cable guide hole on the Lock Module the out to the rotary latch.
6) Install the Cap and Tonneau Harness; insert the red female spade ends of the harness into the Lock Module with the red wire on top. 7) For Cap installations fasten the Cap Harness to the rear door glass using supplied adhesive backed foam tubes installed on the harness. Be sure that the glass is clean and dry then remove the adhesive backing and stick it to the glass.
9) Install the Truck Harness by removing the driver’s side tail light then running the non fused end of the harness up under the bed rail, through the back of the tail light compartment, down to the truck frame following the factory wiring harness to the front of the truck. Run the harness up from the frame, through the firewall and into the driver’s side kick panel. Fasten the harness to the truck securely using the supplied Cable Ties as needed.
VEHICLE WIRING CHART Pop N Lock/ Load N Lock (All wire color information is for reference only and may vary by vehicle) Please verify with a test light If you have trouble locating the lock and unlock wires, test all the wires with a test light that are inside the rubber boot that runs between the door and the cab of the truck to find correct wire colors.
VEHICLE WIRING CHART Pop N Lock/ Load N Lock (All wire color information is for reference only and may vary by vehicle) Please verify with a test light If you have trouble locating the lock and unlock wires, test all the wires with a test light that are inside the rubber boot that runs between the door and the cab of the truck to find correct wire colors.
LIMITED WARRANTY TERMS AND CONDITIONS (1) Installation. Pop & Lock™, LLC (and Pop & Lock™ Corporation) is not responsible for installing the Pop & Lock™ or for the harm suffered by any person as a result installing it. (2) Warranties. a. Customer acknowledges that it is unreasonable to believe that any device whatever will prevent a theft in the case of every attempt and that the most that can be expected from a so-called anti-theft or security device is that it will deter many thieves. b. POP & LOCK™ LLC.
