manual

• Once you’ve assembled the Diagram 3 components onto the end of the filter hose, insert the
prepared end into the opening on the underside of the Solar Heater that you designated as the
INCOMING opening.
NOTE: There are notches on the side hose connectors that need to match to the notch holes on the
Solar Heater openings. Once they are matched up, make sure you turn to lock in place.
• With a new hose, prepare one end as your OUTGOING hose connection by following Diagram 4
for order of parts and connection to each other. This connection will direct the warmed water out
of your Solar Heater and into your pool.
DIAGRAM 4
OUTGOING HOSE CONNECTION COMPONENTS
Hose end (A) + clamp (D) + hose reducer (E) + side hose connector (B) + O-ring (C)
(Use your flat head screwdriver to loosen and tighten the hose clamps)
• Once you’ve assembled the Diagram 4 components,
insert the prepared end with side hose connector
into the other opening on the underside of the Solar
Heater that you designated as the OUTGOING
opening. NOTE: ONCE YOUR SIDE HOSE CONNECTOR
IS IN PLACE, MAKE SURE YOU TURN TO LOCK.
• Turn your Solar Heater over. You should now have
your Solar Heater connected to an INCOMING hose
from your filter (1) and OUTGOING hose (2). Connect
the unattached end into your pool opening where the
warm water from your filter is returned (3).
• Congratulations! You are completely assembled.
Your final assembly should look like Diagram 2.
C
B
E
D
A
(1)
(2)
(3)