manual

• Position 3 = Directs 100% of the water flow through
the bypass hose and directly to your pool. The water from
your filter pump will NOT go through the solar heater
• Position 4 = Directs 100% of the water flow
through your solar heater and is recommended
to be used with low horsepower filter pumps
up to ½ HP
• Position 5 = Allows a half flow of water through
the heater and through the bypass into the pool.
This position is recommended
FAQ’s (Frequently Asked Questions)
Q. My pool water doesn’t seem to be getting any warmer. What should I do?
A. First check to make sure that water is flowing through the tubes. You can simply lift these up and feel the water
within them. Next, check the flow strength at the Pool’s return inlet. Can you feel water flowing into the pool?
Has your Solar Heater been exposed to the sun light for long periods of time? Remember, one Solar Heater
for a 15 – 18 ft pool is recommended. Is your pool larger than this? If you’ve checked all this, you may have
a clog in your tubing. Try to isolate which tube and purge out the clog.
Q. There is a leak at the connection site. What should I do?
A. Hose clamps have been provided to use for all connection sites if able.
Make sure these are on properly and tightened.
Position 3: 100% water
through bypass to pool only
C
Bypass to Pool
From Filter
To Solar Heater
RL
Position 4: 100% water
through solar heater
C
Bypass to Pool
From Filter
To Solar Heater
RL
Position 5: 50% flow
into bypass and solar heater
C
Bypass to Pool
From Filter
To Solar Heater
RL