manual

SOLAR HEATER

FILTER PUMP SYSTEM

BYPASS KIT

INCOMING

HOSE

POOL

WATER

OUT

(1)

(2)

(1)

• Once you’ve assembled the Diagram 7 components, insert the prepared end with side hose connector

into the other opening on the underside of the Solar Heater that you designated as the OUTGOING

opening. NOTE: ONCE YOUR SIDE HOSE CONNECTOR IS IN PLACE, MAKE SURE YOU TURN TO LOCK.

• Turn your Solar Heater over. You should now have your Solar Heater connected to an INCOMING hose

and OUTGOING hose.

• Connect the loose end of the Solar Heater’s

OUTGOING hose (1) to the left end of the

T-connector (2).

Make sure the hose is pushed all the way to the

end of the adaptor. Tighten the hose clamp.

• With a new hose, attach one end to the center opening

of the 3-way valve (1) and the other end into the

center of the T-connector (2).

Make sure the hose is pushed all the way to the

end of the adaptor. Tighten the hose clamp.