Instructions / Assembly

STEP
BALANCE
Chlorine Stabilizer
DIRECTIONS FOR USE:
It is a violation of Federal Law to use this product in any manner inconsistent with its labeling.
Read entire label and use strictly in accordance with precautionary statements, storage, disposal
and directions.
DIRECTIONS FOR USE: Read entire label and use strictly in accordance with precautionary
statements and directions.
• Stabilizer level should be a minimum of 30 ppm.
• Before adding this product, backwash or clean filter.
• Test and balance water before using this product. Visit www.pooltime.com for complete pool
balancing instructions.
Application methods:
• If your pool has a deep end, broadcast product throughout the deep end.
• If your pool does not have a deep end, apply product through the skimmer. First remove any items
from skimmer basket and place in a non-bleachable area away from children and pets. SLOWLY add
product directly into the skimmer with the filter and pump operating.
• For freshly filled pools, add 1 lb per 4,000 gallons.
• At pool opening, test stabilizer. If stabilizer level is below 30 ppm, add 1 lb per 4,000 gallons.
• After adding this product, keep water circulating continuously for 24 hours. When the chemical
reaches the filter, there may be a temporary increase in filter pressure which will cease as the
chemical dissolves.
• AFTER ADDING this product, DO NOT BACKWASH FILTER for at least 48 hours.
IN CASE OF MEDICAL EMERGENCY, CALL 1-877-800-5553.
NOTE: User assumes all responsibility for use not in accordance with directions.