User manual

- EN -

Installation and connection

How to proceed:

 B, C

1. Place the unit and the connected artificial water lily into the water.

– The artificial water lily floats on the surface of the water.

2. Route the connection cable to the socket.

– Switching on: Connect the connection cable to the mains. The LEDs in the float will light up, the pump will start

operating.

– Switching off: Disconnect the connection cable from the mains.

3. Set the desired bubbling intensity.

– To increase the bubbling intensity: Turn the valve knob clockwise.

– To reduce the bubbling intensity: Turn the valve knob counterclockwise.

Remedy of faults

Malfunction Cause Remedy

LEDs are not lit No mains connection Connect the connection cable to the mains.

Connection defective Check the electrical connection.

Insufficient bubbling intensity. Valve soiled Clean the valve.

Air hose kinked or porous Replace the air hose.

Insufficient or no pump delivery. The pump filter housing is soiled. Clean the pump filter housing.

The impeller unit is blocked. Clean the pump.

The impeller unit is worn. Replace the impeller unit.

Maintenance and cleaning

The unit has to be taken out of the water for cleaning or maintenance.

Attention! Dangerous electrical voltage.

Possible consequences: Death or severe injury.

Protective measures:

 Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:

Isolate the units and installations (switch off and disconnect from the power supply) before reaching into

the water.

 Isolate the unit before starting any work.

 Secure the unit to prevent unintentional switching on.

Cleaning the unit

Note!

Recommendation on regular cleaning:

 Clean the pump as required but at least twice a year.

 Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the

function.

 Recommended cleaning agent for removing stubborn limescale deposits:

– Vinegar- and chlorine-free household cleaning agent.

 After cleaning, thoroughly rinse all parts in clean water.