Product Manual

CARE AND OPERATING INSTRUCTIONS FOR
MINI MAGNETIC DRIVE MODEL 65 PUMP
The model 65 is a compact economical pump designed to be used with table top and wall fountains as
well as small statuary with a limited space to conceal a pump. A
3
/
8
” or
1
/
2
” inside diameter hose may be
connected to the outlet in conjunction with the flow control it is possible to direct and adjust the flow of
water. This can be useful in controlling spray and splashing in fountains and statuary.
In combining aquariums / terrariums the use of a hose can be helpful in creating a waterfall and distrib-
uting the water away from the pump area. With the screen placed down it will pump in as little as 2” of
water.
The housing should occasionally be removed to clean and inspect the impeller assembly. To remove cover
place thumb on bottom between suction cups and press while pulling screen away from pump body.
Note shaft is not removable. The impeller is the only serviceable item and can be pulled out of the body.
Clean housing under faucet. Use “Q” tip if necessary and reinstall. Pumps taken out of service for an
extended period with fluid inside run the risk of forming a crust which may prevent subsequent starting.
Salt water should be flushed out with fresh water. Always check cord for sharp bends which can cause
premature cracking. Do not use power cord to lift or move pump.
Always use a properly grounded outlet. Do not immerse plug in water. DO NOT REACH INTO WATER TO
REMOVE PLUG. TURN OFF CIRCUIT FIRST. A “Drip Loop” should be provided. The Drip Loop is a loop in
the cord below the level of the receptacle or plug that prevents water from traveling along the cord.
The National Electric Code requires that a ground fault circuit interrupter (GFCI) be installed in the
branch circuit supplying fountain or pond equipment. Your dealer can supply GFCI units. NEVER REMOVE
GROUND PIN FROM PLUG. WARNING: FOR YOUR PROTECTION ALWAYS UNPLUG THE UNIT FROM
ITS POWER SOURCE BEFORE INSTALLING OR SERVICING. SHOULD THE UNIT APPEAR TO NOT BE
WORKING DO NOT REACH, REMOVE OR DISASSEMBLE UNIT BEFORE YOU DISCONNECT POWER.
The pump is intended to pump water only. It cannot be used to pump oils, solvents or gasoline.
CAUTION: PONDS CAN BE DANGEROUS TO SMALL CHILDREN.
NEVER LEAVE A CHILD UNSUPERVISED NEAR A POND
E.G. Danner Mfg. Inc will repair or replace any pump found to be defective within one year of original
purchase. This warranty does not cover the replaceable filtering material supplied with the pump as it is
considered expendable. Cutting or altering cord voids any warranty consideration. For warranty repair
return only the part that is defective to our factory. Please include a dated proof of purchase and
$5.00 for postage and handling. Damages or injuries resulting from negligence or misuse of the product
are not covered by warranty. This warranty gives you specific legal rights. You may have other rights which
vary from state to state.
LIMITED WARRANTY
ELECTRICAL PRECAUTIONS
SERVICE AND MAINTENANCE
FEATURES
PAGE ONE
ZG195 11/10
DANNER MFG. INC. 160 OVAL DRIVE, ISLANDIA, NEW YORK 11749-1489
Important Safety Instruction
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE
INSTRUCTIONS