Installation Guide

ManualsBrandsPond Building Series ManualsOutdoors9-Watt Pond Replacement UV Light

WARNINGS AND CAUTIONS

WARNING

 WARNING – Improper connection of the appliance-grounding conductor can result in a risk of

electric shock. Check with a qualified electrician or service representative if you are in doubt whether

the appliance is properly grounded. Do not modify the plug provided with the appliance; if it will not fit

the outlet, have a proper outlet installed by a qualified technician. 

 Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is

damaged in any manner. 

 Always unplug the appliance from the outlet before putting on or taking off parts, before cleaning or

when not in use. 

 Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI). 

 Risk of Electric Shock: Do not use the UV filter if the quartz tubing around the lamp is broken.

Immediately unplug and seek an authorized repair service or discard the unit.

 GROUNDING INSTRUCTIONS – This appliance must be grounded. In the event of a malfunction or

break down, grounding will reduce the risk of electric shock by providing a path of least resistance

for electric current. This appliance is equipped with a cord having an appliance-grounding conductor

and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and

grounded in accordance with all local codes and ordinances. 

CAUTION

 UV light may cause irritation to the skin and/or eyes. Avoid exposure. 

 DANGER – ULTRAVIOLET RADIATION – disconnect power before replacing lamp. 

 Prolonged or repeated exposure to UV light may have adverse physical effects including, severe

damage to your skin and eyes. Seek immediate medical attention for overexposure to UV

radiation. 

 Keep the cord away from high temperatures or other heat sources. 

 Do not lift the light or the transformer by its power cord. 

 This light assembly has not been investigated for use in swimming pools or hot tubs. 



ASSEMBLY INSTRUCTIONS

1. Open and remove the light assembly from the

package and untie the power cord. Turn the locking

ring counterclockwise to remove the lamp holder.

2. Install the bulb into lamp holder (02). Reinstall the

lamp holder and locking ring.

3. Install the adapter gasket (06), adapter (04), and

adapter locking nut (05) onto the inlet and outlet of the

lamp housing.

NOTE: FOR A PROPER SEAL, THE PARTS MUST BE

INSTALLED IN THIS SPECIFIC ORDER.

4. Connect tubing from the outlet of your pump to the

inlet . The adapters included can connect to 1/2-in. or

3/4-in. tubing. We recommend 1/2-in. tubing for

optimum performance.

NOTE: THE INLET IS MARKED “IN” ON THE LAMP

HOUSING

5. Connect tubing to the outlet. The other end can be

connected to a spouting statue, waterfall, or any other

water feature for your pond.

NOTE: THE OUTLET IS MARKED “OUT” ON THE LAMP

HOUSING.

6. Plug the unit into a properly grounded electrical outlet.

PUMP

(SOLD SEPARATE)

TUBING

(SOLD SEPARATE)

PUMP IN WATER

CONNECT TO

WATER FEATURE

GFCI

SPECIFICATIONS

LAMP VOLTAGE 60V LAMP CURRENT 0.2A

LAMP POWER 9 W RATED FREQUENCY 60 HZ

UV IRRADIANCE 35 µW/cm

BULB LIFE 8000 HOURS

BULB MODEL NUMBER AD46529 UV WAVE LENGTH UV(C) ·254 nm