Installation Guide

WARNING: IMPORTANT SAFETY INFORMATION:
Inspect before use for any damage to the unit or power cord. Any damage or missing parts
should be reported immediately and before attempting use. Units with ANY damage to the
power cord should not be used. Contact us for replacement.
Failure to follow these instructions and warnings may lead to product damage or personal
injury of which Angelo Décor International Inc. will not be held liable.
1. NEVER leave children unsupervised or out of sight around ANY pond
environment.
2. Always unplug power from lights, pumps or other electrical devices BEFORE
putting hands in water, or if service and maintenance is performed.
3. Always use properly grounded (GFCI) electrical equipment and a drip loop on any
power cords to prevent water from travelling along the cord.
4. Keep the power cord away from high temperatures.
5. Do not exceed the voltage as indicated on the transformer.
6. Do not submerse the transformer or sensor in water.
7. LIGHT CAN BE HOT - Allow light to cool before handling or disassembling.
8. Always use a cloth when handling the lens or bulb. Oil from your skin can
damage the halogen bulb.
9. Do not use near flammable liquids.
10. Do not use in temperatures below 3
0
Celsius as freezing damage may occur.
TIPS BEFORE INSTALLATION
Ensure the lens, seal, and protective ring are
clean, free from debris, and forms a tight seal
against the housing unit.
Assess the angle you will require and
adjust the unit before placing in pond.
Determine if colored lenses will be used before placing the unit in pond.
Choose an area for your transformer and night sensor that will protect them from heat
sources, excess water, dirt and debris.
Night sensor unit should be placed FACE UP
in an area that gets daylight for proper operation.
Use landscape materials such as stones to hide excess cord,
taking care not to puncture or damage the cord in any way.
INSTRUCTIONS FOR USE
1. Assemble and adjust the housing units WITHOUT PLUGGING IN.
2. Place lights in water on a stable surface, with clear access to features intended to
illuminate, keeping all plugs and socket ends out of water.
3. Attach the light cord plug socket firmly
into the female end of night sensor,
AND
4. Attach the male end of
night sensor to transformer.
5. Screw both socket cap nuts on hand tight.
6. Plug transformer into a GFCI outlet, KEEPING IT OUT OF THE WATER.
REPLACING THE 10 WATT HALOGEN BULB
DISCONNECT UNIT FROM POWER SUPPLY BEFORE HANDLING
Allow unit to cool before attempting to change the bulb. Please use a cloth when handling
the bulb as oils from your skin can damage the bulb.
1. Disassemble the protective
ring by turning
counterclockwise
2. Remove Lens
3. Gently unplug the bulb
from the housing socket.
4. Replace Bulb
5. Reassemble the unit,
ensure seal in place, close protective
ring tightly, turning clockwise.