User's Manual

PolyVision 30
Preparing to use ēno
If you use the older PolyVision Bluetooth adapter...
If you upgraded to the PolyVision driver version 2.4 or higher, you may be
using the original PolyVision Bluetooth adapter rather than the newer ēno
receiver.
If you use the original PolyVision Bluetooth adapter, the ēno stylus
establishes a Bluetooth connection to the host computer rather than to the
Bluetooth adapter. As a result, you need to unpair the ēno stylus from the
host computer before you can move it to a different host computer.
To unpair the stylus from the host computer:
1. Click the PolyVision driver icon on the host computer.
2. Choose “Configure the PolyVision driver” from the menu.
3. Click the “Hardware” tab.
4. Turn on the ēno stylus by removing its cap.
5. Select the ēno stylus in the list of pens in the “Hardware” tab.
6. Click “Remove Stylus.”
note:
NOTE:
For Windows or Macintosh users, if you chose to use the operating
system’s Bluetooth capability to pair the ēno stylus rather than the
PolyVision Bluetooth adapter, you can unpair the stylus as you would
remove any Bluetooth device. Refer to “Appendix 1: ēno Bluetooth pairing
options” on page 69 for information about all pairing options.
If you are using third-party Bluetooth capability that was added to the host
computer, unpair the stylus using instructions provided by your Bluetooth
product. The stylus is listed as device ADP-301.
newer ēno receiver older PolyVision Bluetooth adapter