User's Manual

PolyVision 28
Preparing to use ēno
Troubleshooting: If pairing was not successful, you can try to
resolve the problem by removing the ēno receiver from the USB port
on the host computer, waiting five seconds, and reinserting it before
attempting the pairing process again.
note:
NOTE:
If you want to use a third-party Bluetooth product on your computer to pair
with the ēno stylus, use the instructions provided by your product and refer
to “Appendix 1: ēno Bluetooth pairing options” on page 69. The stylus is
identified as device ADP-301.
ēno receiver LED status summary and troubleshooting
If the ēno receiver LED is green and…
• Flashes five times after you attempted pairing, the stylus and the ēno
receiver have been successfully paired.
• Flashes three times when you removed the stylus cap (after the stylus
has been paired and the PolyVision driver 2.4 or higher is running), the
ēno stylus has successfully re-connected to your computer.
If the ēno receiver LED is blue and…
• Is solid blue, the PolyVision driver is communicating with the ēno
receiver.
• Is flashing as you use the stylus, data is streaming from the ēno stylus to
your computer successfully.
If the ēno receiver LED is red and…
• Quickly flashes five times after you attempted pairing, the stylus and the
ēno receiver have not been successfully paired. You need to start the
pairing process over again.
• Flashes three times when you removed the stylus cap (after the ēno
stylus has been paired and the PolyVision driver 2.4 or higher is
running), the ēno stylus has not been successfully connected to your
computer. You need to cap and uncap the stylus again.
• Is solid red, the PolyVision driver is not updated to version 2.4 or higher,
or the driver is not running. Launch the PolyVision driver version 2.4 or
higher on the host computer and start the pairing process over again.