User's Manual
Table Of Contents
- Welcome
- Installing ēno interactive whiteboards
- Preparing to use ēno
- Using ēno interactive whiteboards
- Get started using ēno interactive whiteboards
- ēno interactive whiteboard control icons
- Projector control icons (for the PolyVision projector)
- Cursor control using the ēno stylus
- Using the on-screen keyboard
- Writing and erasing with the ēno stylus
- Printing and saving
- Spotlight and reveal options
- Opening a blank window for writing
- The PolyVision driver
- Configuring PolyVision driver options
- Configuring PolyVision projectors
- Choosing alignment accuracy
- Using on-screen tools
- Getting help
- Checking for updates
- Exiting the PolyVision driver
- To uninstall the PolyVision driver in Windows
- To uninstall the PolyVision driver on a Macintosh
- To uninstall the PolyVision driver using Linux
- Care and maintenance
- Technical support
- Warranty
- Appendix 1: ēno Bluetooth pairing options
- Index
PolyVision 25
Preparing to use ēno
Preparing to use ēno
ēno is ready to use after you:
• add batteries to the ēno stylus.
• pair the ēno stylus Bluetooth signal with the PolyVision ēno receiver.
Refer to “Pair the ēno stylus with the ēno receiver” on page 26.
• connect a projector to the computer.
Stylus batteries
Install the ēno stylus battery
The ēno stylus requires one AAA battery (provided).
To install the battery:
1. Open the battery compartment.
2. Insert the battery.
3. Replace the battery compartment lid.
Power on and off the stylus
To turn the ēno stylus on and off:
• Remove and replace the stylus cap.