User's Manual

COPYCAM QUICK START 3
COPYCAM QUICK START
Step 1: Write on the board.
Step 2: Press a button on the control pad.
Step 3: You’re done!
CopyCam captures the board and you can continue your
presentation without interruption.
WHAT TO EXPECT
In good lighting conditions, CopyCam captures the board just five
seconds after you press one of the control pad buttons. In poor light,
it might take a few seconds longer.
NOTE:NOTE:
To avoid shadows across the image, be sure you stand away from the
board when you press the control pad button.
A voice prompt quietly says “captured.” At the same time, the LED
changes from blinking yellow to solid yellow to indicate that you can
erase the board and continue writing. Refer to “LED and Voice Status
Messages” on page 26 for a summary of all status messages.
When you use the printer, it can take up to 45 seconds before a copy
starts printing, but you can continue with your presentation during
that time.
When you use the floppy diskette, it can take up to a minute to save
the file, but you can continue with your presentation during that time
as well.
Userguide_RevA_4.fm Page 3 Friday, January 18, 2002 11:07 AM