User's Manual

IMPULSE
™
LTX Multimedia Whiteboard
54 Troubleshooting
LED and Status Messages
The Impulse system gives you both LED and audible feedback to
indicate the status of your capture.
LED STATUS INDICATORS
The table below explains the LED status indicator for the Printer
button.
The table below explains the LED status indicator for the Disk button.
LED INDICATOR SYSTEM STATUS
Blinking green Copy is being printed. You may continue writing on
the board.
Blinking yellow No printer has been configured. (The voice prompt
provides additional information.) Refer to “The
Admin Network Subsection” on page 39.
Blinking red There is a printing error. The printer may be out of
paper, not powered on, or other attention is
required. (The voice prompt provides additional
information.)
LED INDICATOR SYSTEM STATUS
Blinking green Copy is being saved. You may continue writing on the
board.
Blinking yellow No diskette in the floppy drive. (The voice prompt
provides additional information.)
Blinking red There is a problem with the diskette, or the diskette
is full. (The voice prompt provides additional infor-
mation.)
LTX_UG_5.fm Page 54 Friday, June 13, 2003 11:02 AM