User's Manual

The Impulse System Maintenance 49
The Impulse System Maintenance
Cleaning the Board
Wipe the control panel with a soft damp cloth.
To clean the ceramicsteel marker board surface, see instructions
below or refer to www.cleanmyboard.com.
DAILY CARE AND MAINTENANCE
1 For the initial cleaning, wipe your board with a clean cloth
moistened by a liquid cleanser.
2 Rinse with clear water. This step is simple but very important.
NOTE:NOTE:
Do not let water seep into the sensitive Impulse electronics. Your
warranty does not cover damage caused by water.
3 Wipe dry with a clean cloth.
4 If your board is used daily, the cleaning should be performed at
least 2 to 3 times a week. More thorough cleaning may be
required if writing is left on the board for more than 2 days.
REMOVING CRAYON AND TAPE
The same procedure is used to remove both crayon and tape.
1 Dampen a clean, dry cloth with water.
2 Sprinkle a small amount of non-abrasive cleaner, such as Scrub
Soft, onto the cloth.
3 Begin cleaning a small, manageable area using a back and forth
horizontal motion. Use normal pressure as if you were cleaning a
window.
4 Wipe off all residue with a dry cloth.
5 Rinse well with clear water. Please note that the rinsing and
drying steps are very important.
LTX_UG_5.fm Page 49 Friday, June 13, 2003 11:02 AM